Weber Premium Cover User Manual

Premium Cover Installation
for the Summit 475 & 675
View from Top
Front
Install
screws
here
You will need: twelve stainless steel male snap half/screws
and a drill. (Fourteen snaps are supplied, two are spares.)
1. Place the cover over the Summit Gas Barbecue. The
cover should lay flat on top of the trim of the sleeve.
Mark the trim opposite the snaps. Remove the cover.
2. Use the drill to drill a small pilot hole in the trim.
(.140” (
9
⁄64) drill size, countersunk 60° x .050” deep
maximum or a larger drill size to remove the burr)
Note: The dimensions shown indicate the approximate
locations of the stainless steel mounting snaps The female
top snap (part of cover) should be used as a template for
drilling holes for the male bottom part of the snap.
3. Screw the male snap half into the pilot hole.Tighten.
Repeat for the other nine male snap half/screws.
4. Place the cover over the barbecue. Snap it into place.
5. Make sure the inner “skirt” of the cover material is
under the handle and draped over the control panel.
This will allow any water to run off and not collect in
the handle area.
Figure 2
Approximate
dimensions for
the Summit 475
1”
9
1
⁄2”
View from Top
Front
Install
screws
here
Figure 3
Approximate
dimensions for
the Summit 675
Top of
sleeve trim
Top of
sleeve trim
Figure 1
1”
97368 12/98
2
1
⁄2”
11
5
⁄8”
12”
1”1”
9
1
⁄2”
1”
2
1
⁄2”
11
5
⁄8”
12”
3
1
⁄4”
3
1
⁄4”
1”
15
1
⁄2”
1”1”
15
1
⁄2”
3
1
⁄4”
3
1
⁄4”
Figure 4
View from front
9”
9”
1”1”

Weber Premium Cover Specifications

General

Material	Polyester
Color	Black
Weather Resistant	Yes
UV Resistant	Yes
Breathable	Yes

Summary

Premium Cover Installation for Summit 475 & 675

Initial Cover Placement and Marking

Place cover on grill, ensure it lays flat, mark snap positions, and remove cover.

Drilling and Countersinking Pilot Holes

Drill pilot holes in trim using specified drill size and countersink for snap attachment.

Attaching Male Snap Fasteners

Screw male snap halves into pilot holes and tighten securely.

Final Cover Attachment

Position cover over barbecue and snap into place.

Proper Skirt Draping for Water Runoff

Ensure inner skirt is under handle and over control panel for effective water drainage.