CELL PHONE SIGNAL BOOSTER
3
4
CONNECT COAX CABLES TO DRIVE 4G-X
Select a location for the Drive 4G-X that is free
from excessive heat, direct sunlight and moisture
and that has proper ventilation. Good locations
include underneath a seat or under the dashboard.
Connect the cable from the 4G-OTR Antenna to the
port labeled “Outside Antenna” on the Drive 4G-X
and connect the cable from the Slim Low Profile
Antenna to the port labeled “Inside Antenna” on
the booster.
5
CONNECT TO POWER SUPPLY
Connect the power supply cord to the end of the
Drive 4G-X labeled “Power.” NOTE: Do NOT connect
the power to the Signal Booster until you have
connected both the Inside and Outside Antennas.
6
CONNECT TO POWER SUPPLY
Plug the power adapter into vehicle’s 12V DC
power supply. Power up your Drive 4G-X by
flipping the switch on the back of the DC power
adapter on. If your Drive 4G-X is working correctly,
the light will be green.
NOTE: If light is not green on your weBoost booster,
please refer to the troubleshooting section on page
8 or contact customer support at 1-866-294-1660
or email at support@weboost.com.
Slim Low
Profile
Antenna
4G-OTR
Antenna
switch
Vehicle’s Power
Supply
To Next Page
Loading...
