14
CELL PHONE SIGNAL BOOSTER HOME MULTIROOM
______
Light Patterns
Solid Green
This indicates that your booster is
functioning properly and there are
no issues with installation.
Blinking Green & Red
Band has reduced gain. This indicates
that one or more of the booster bands has reduced power due to a feedback loop
condition called oscillation. This is a built in safety feature to prevent harmful interference
with a nearby cell tower. If you are already experiencing the desired signal boost, then
no further adjustments are necessary. If you are not experiencing the desired boost in
coverage then refer to the Troubleshooting section.
Solid Red
Band has shutoff. This is due to a feedback loop condition called oscillation.
This is a built in safety feature that causes a band to shut off to prevent harmful
interference with a nearby cell tower. Refer to Troubleshooting section.
Blinking Green & Yellow
Band has reduced gain. This indicates that one or more of the booster bands has reduced
power due to overload from nearby cell tower. This is a built in safety feature to
prevent harmful interference with a nearby cell tower. If you are already experiencing
the desired signal boost, then no further adjustments are necessary. If you are not
experiencing the desired boost in coverage then refer to the Troubleshooting section.
Solid Yellow
Band has shutoff due to overload from nearby cell tower. Outside Antenna must be
adjusted. Refer to Troubleshooting section.
Light O
If the Signal Booster’s light is off, verify your power supply has power.
BU-GDE000144-003-012120.indd 14BU-GDE000144-003-012120.indd 14 1/21/2020 3:34:16 PM1/21/2020 3:34:16 PM
To Next Page
Loading...
Need help?
General
