weBoost Home MultiRoom User Manual

2
CELL PHONE SIGNAL BOOSTER HOME MULTIROOM
______
Preparation
NOTE: These instructions will walk you through a “soft” install process to find
the optimal locations for the inside and outside antennas, then through the
process of the permanent installation.
You Will Need (tools not included)
Make sure the following materials are prepared and ready for your
installation.
o Ladder
o Drill (if routing cable through wall)
o 1”-3” diameter existing pole for mounting
Outside Antenna (#901117 Pole Mount can be
purchased separately if needed)
o Recommended: Power Strip with surge protection
1 to 2 hours
1 Person (2 people to make antenna calibration easier)
BU-GDE000144-003-012120.indd 2BU-GDE000144-003-012120.indd 2 1/21/2020 3:34:11 PM1/21/2020 3:34:11 PM

weBoost Home MultiRoom Specifications

General

Max Gain	65 dB
Model Number	470144
Coverage	Up to 5, 000 sq ft
Indoor Antenna	Panel Antenna
Power Source	AC Power Adapter
Frequency Band	700 MHz, 800 MHz, 1700 MHz, 1900 MHz
Impedance	50 Ohm
Power Supply	AC 110-240V
Connectors	SMA
Downlink Power	12 dBm
Power	12V DC
Bands Supported	4G LTE, 3G, 2G
Outdoor Antenna	Yagi
Compatible Carriers	AT&T, Verizon, T-Mobile, Sprint
Dimensions (Indoor Antenna)	8 x 6 x 1.5 inches
Cable Length	30 ft