How to fix over current alarm on Weco HeSU 4k4 PRO Battery Pack?
If you are experiencing an over current alarm with your Weco Battery Pack, it means the battery relay is disconnected during charging or discharging, and the battery fault light is flashing. To resolve this, reduce the charge or discharge current.
What to do if get over voltage alarm on Weco HeSU 4k4 PRO Battery Pack?
If you're getting an over voltage alarm on your Weco Battery Pack, it means the battery relay is disconnected when charging, and the battery fault light is flashing. To fix this, stop charging and review and properly reset the inverter settings. Weco suggests using Closed Loop CAN-BMS inverters.
What to do if I get a low voltage alarm on my Weco HeSU 4k4 PRO Battery Pack?
If you are experiencing a low voltage alarm with your Weco Battery Pack, it means the battery relay is disconnected when discharging, and the battery fault light is flashing. Stop discharging from the battery and charge the battery in accordance with the correct charging procedure.
How to fix master-slave machine communication exceptions on Weco HeSU 4k4 PRO Battery Pack?
If you're experiencing master-slave machine communication exceptions with your Weco Battery Pack, and the slave battery fault light flashes while the master machine cannot control the slave battery, check that the communication cables between the master battery and the slave batteries are securely connected.
What to do if first parallel connection failure of batteries on Weco HeSU 4k4 PRO Battery Pack?
If you experience a first parallel connection failure of batteries with your Weco Battery Pack, indicated by the slave battery fault light flashing and no voltage output, measure the positive and negative voltage of each battery. If the voltage difference between the batteries is greater than 2V, reduce the voltage difference to less than 2V to try parallel connection.
What to do if I get an OVER VOLTAGE ALARM on my Weco Camera Accessories?
If your Weco Camera Accessories battery relay disconnects during charging, and the battery fault light flashes due to over voltage, immediately stop charging. It is recommended to review and properly reset the inverter settings, and WeCo suggests using Closed Loop CAN-BMS inverters.
How to fix OVER CURRENT ALARM on Weco Camera Accessories?
An OVER CURRENT ALARM on your Weco Camera Accessories indicates the battery relay disconnected during charging or discharging, and the battery fault light is flashing. To resolve this, reduce the charge or discharge current.
What to do if I see a LOW VOLTAGE ALARM on my Weco Camera Accessories?
If you get a LOW VOLTAGE ALARM on your Weco Camera Accessories, it means the battery relay disconnected during discharging, and the battery fault light is flashing. Stop discharging the battery and charge it according to the correct charging procedure.
What to do if my Weco Camera Accessories shows a LOW TEMPERATURE ALARM?
A LOW TEMPERATURE ALARM on your Weco Camera Accessories means the battery can't charge or discharge normally. Wait for the battery temperature to rise to a suitable level before attempting to charge or discharge it.
General| Brand | Weco |
|---|---|
| Model | HeSU 4k4 PRO |
| Category | Battery Pack |
| Language | English |
To Next Page
