ig Series HMI Installation Manualig V2.0
Part 11 Product Installation
Notes:
The installation direction must be in accordance,Otherwise it may lead to fault.
In order to make circle effect greatly,adjacent objects and baffle should be kept on enough space
when installation,otherwise it will cause bad cooling.
Used in crust plane of Type 4X indoor grade.
Installation steps:
Make sure the waterproof gasket is cased,and then install HMI to the adaptive crust.
Make sure the fixed piece screw is cased,and then hitch front cover screw to withstand inside
control box .
Please tight screws aptly and remember not too strength,otherwise it will lead to crustaceous
damage. Torque:6.17lb-inch(0.7N-M)
Part 12 Interface Definition
PI3070ig / PI8070ig / PI3102ig / PI8102ig / PI8150ig / PI8150ig(N) series interfaces
COM1 definition:
▲ Note:RS422 and RS485-1 can not be used in COM1 port of PI3070ig / PI8070ig / PI3102ig /
PI8102ig / PI8150ig / PI8150ig(N) series HMI at the same time.
Notice
The contents of this manual are subject
to change without notice.
Wecon Technology Fu Zhou
Address 10 Building, E area, Fuzhou:
Software park, Fujian, P. R. China ;
;Tel 0086-591-87868869:
;Email sales@we-con.com.cn:
;Web www we con com cn en: . - . . /
维控科技
WECONTECHNOLOGY
R
WECON_ig_20230701
To Previous Page
Loading...