3
electrical rating not less than the rating
of unit. Cord must be marked with suf-
fix “W --A” (in Canada “W”). Make sure
your extension cord is in good condi-
tion. Inspect extension cord before use
and replace if damaged. Do not use a
damaged cord. Cord insulation must
be intact with no cracks or deteriora-
tion. Plug connectors must be undam-
aged. An undersized extension cord
will c ause a drop in line voltage result-
ing in loss of power and overheating. If
in doubt, use the next heav ier gauge.
The lower the gauge number, the
heavier the cord (see
SELECT AN EX-
TENSION CORD
). Do not use multiple
cords.
S Do not abuse cord. Never carry the unit
by the e xtension cord or yank exten-
sion cord to disconnect unit.
S Use co rd retainer to prevent discon-
nection of extension cord from unit.
See
ATTACH THE EXTENSION CORD TO
YOUR TRIMMER
in the OPERATION sec-
tion
.
S Do not use the unit if the s witch does
not turn the unit on and off properly. Re-
pairs to the switch must be made by
your authorized service dealer.
S Keep the extension cord clear of o per-
ator and obstacles at all times. Do not
expose cords to heat, oil, water, or
sharp edges.
S To avoid the possibility of electric
shock, avoid body contact with any
grounded conductor, such as metal
fences or pipes.
S Ground Fault Circuit Interrupter (GFCI)
protection should be provided on c ir-
cuit or outlet to be us ed. Receptacles
are available having built-in GFCI
protection and may be used for this
measure of s afety.
UNIT SAFETY
S Inspect unit before use. Replace dam-
aged parts. Make sure all handles,
guards, and fasteners are in place and
securely fastened. Parts that are dam-
aged must be repaired or replaced by
an authorized s ervice dealer. This in-
cludes head parts that are cracked, or
chipped, guards, and any other part
that is damaged.
S Do not repair unit y ourself.
S Use only 0.065” (1.65 mm) diameter
recommended trimmer line (see
ACCE-
SORIES
). Never use wire, rope, s tring,
etc.
S Use specified trimmer spool. Make
sure spool is properly installed and all
parts are securely fastened.
S Use only recomme nde d WE ED EATER
repl acement part s and accessories.
CUTTING SAFETY
S Inspect area to be cut. Remove objects
(rocks, broken glass , nails, wire, string,
etc.) which can be thrown or become
entangled in cutting head.
S Do not overr each or stand on unstable
support. Keep fir m footing and balance.
S Keep the cutting head below waist lev-
el. Do not raise handles a bove your
waist. Cutting head c an come danger-
ously close to your body.
S Keep away from cutting head and spin-
ning line.
S Use unit properly. Use only for trim-
ming, edging, and mowing. Do not
force unit; it will do the job better and
with less risk of injury at the rate for
which it was designed.
S Use only in daylight or in good artificial
light.
MAINTENANCE SAFETY
WARNING: Disconnect u nit from
the power supply before performing
maintenance, or when chang ing trimmer
line.
S Maintain unit according to recom-
mended procedures. Keep cutting line
at proper length. Follow instructions for
changing trimmer line.
S Have all service and maintenance not
explained in this manual performed by
an authorized service dealer to avoid
creating a hazard.
S Never douse or squirt the unit wi th water
or any ot her liqui d. Clean unit and labels
wit h a damp sponge. Keep handles dry,
clean, and free fr om oil and grease.
S Keep the a ir vents clean and free from
debris to avoid overheating the motor.
Clean after each use.
TRANSPORTING AND STORAGE
S Stop the unit and disconnect the power
source when not in use.
S Carry the unit with motor stopped.
S Store the unit s o that the line limiter
blade (on underside of shield) cannot
cause injury.
S Store unit indoors in a high, d ry place
out of the reach of children. Store unit
unplugged.
DOUBLE INSULATION
CONSTRUCTION
This unit is double insulated to help pro-
tect against electric shock. Double in-
sulation c onstruction cons ists of two
separate “layers” of electrical insulation
instead of grounding.
To Next Page
Loading...
