EasyManua.ls Logo

Weed Eater RT112C - User Manual

Weed Eater RT112C
9 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
RT112C
R Trademark
Instruction Manual
Manual de Instrucciones
Manuel d’Instructions
ENGLISH
ESPAÑOL FRANÇAIS
545117 537 8/8/06
Please do not return unit to retailer.
Por favor, no devuelva el aparato al lugar de compra.
Veuillez ne pas retourner l’outil au détaillant.
1- 800-554-6723
www.weedeater.com
WEED EATER
1030 Stevens Creek Road
Augusta, GA 30907
WEED EATER
5855 Terry Fox Way
Mississauga, Ontario L5V 3E4
WARNING:
Read an d follow all Safety Rules and Operating Instructions before
using this product. Read instructions carefully before assembling.
Failure to do so can result in serious injury.
ADVERTENCIA:
Lea el manual del operador y siga todas las advertencias e instruc-
ciones de seguridad. Antes de ensamblar el producto lea cuidado-
samente el instructivo. El no hacerlo puede resultar en lesiones gra-
ves.
AVERTISSEMENT:
Veuillez lire le manuel de l’utilisateur et bien respecter tous les
avertissements et toutes les instructions de sécurité. Bien lire les
instructions avant d’assemble r l’outil. Tout défaut de le faire pourrait
entraîner des blessures graves.

Table of Contents

Questions and Answers

  • J
    Jennifer JohnsonJul 30, 2025
    What to do if the Weed Eater RT112C Trimmer head stops under load?
    • L
      Linda MckenzieJul 30, 2025
      If the trimmer head of your Weed Eater Trimmer stops under a load, ensure you're allowing the tip of the line to do the cutting, instead of crowding the line against the material. Also, check the breaker box, and remove any debris that may be stopping the head. If those steps don't resolve the issue, it could be due to an electrical failure, in which case you should contact your authorized service dealer.
  • N
    Nathan MathewsAug 4, 2025
    Why does the line on my Weed Eater RT112C Trimmer keep breaking?
    • T
      Timothy ShawAug 4, 2025
      If the line of your Weed Eater Trimmer does not advance or breaks while cutting, check the line routing and rewind the line tightly and evenly onto the spool. Ensure you are using the correct line size (0.065 in. (1.65 mm) dia.). Also, make sure there's enough line outside of the head by removing the cover and pulling 4 inches (10 cm) of line out. Clean the unit to remove any dirt buildup.
  • N
    Natasha BarnesAug 9, 2025
    How to stop the line pulling back into the Weed Eater RT112C Trimmer head?
    • L
      Leslie HoffmanAug 9, 2025
      If the line is pulling back into the head of your Weed Eater Trimmer, make sure there is enough line outside of the head. You can add more line by removing the cover and pulling 4 inches (10 cm) of line outside of the head. Also, ensure you are using the correct line size (0.065 in. (1.65 mm) dia.).
  • I
    irwinrichardAug 13, 2025
    What to do if the line releases continuously on my Weed Eater RT112C Trimmer?
    • A
      Anthony VasquezAug 13, 2025
      If the line of your Weed Eater Trimmer releases continuously, check the line routing in the head. A damaged spool can also cause this issue, so replace the spool if necessary.
  • A
    Ashley WeaverAug 19, 2025
    Why is the line usage excessive on my Weed Eater RT112C Trimmer?
    • J
      Joseph HernandezAug 19, 2025
      Excessive line usage in your Weed Eater Trimmer can be caused by several factors. First, check the line routing in the head. Ensure you are using the correct line size. Crowding the line against the material you're cutting can also lead to excessive usage, so cut with the tip of the line fully extended. Finally, a worn or damaged spool may be the culprit, so consider replacing it.
  • A
    Amy ColemanAug 25, 2025
    How to prevent line from welding onto the spool of my Weed Eater RT112C Trimmer?
    • L
      Lauren HuffmanAug 25, 2025
      If the line welds onto the spool of your Weed Eater Trimmer, ensure you are using the correct line size (0.065 in. (1.65 mm) dia.) and the correct spool. Also, avoid crowding the line against the material you are cutting; instead, cut with the tip of the line fully extended.

Summary

Safety Rules

Safety Information On The Unit

Understand the unit's safety features and operator responsibilities before use.

Operator Safety

Guidelines for operator protection including clothing, alertness, and proper handling.

Electrical Safety

Precautions to prevent electric shock when using the appliance.

Maintenance Safety

Safety procedures for maintaining the unit, including disconnection and cleaning.

Transporting And Storage Safety

Assembly

Tube Assembly

Steps for correctly assembling the trimmer's upper and lower tubes.

Installation Of Assist Handle

Attaching The Shield

Operation

Know Your Trimmer

Familiarize yourself with the unit's controls, components, and their functions.

Select An Extension Cord

Correct Operating Position

Maintenance

Service And Adjustments

Replacing The Line

User Replaceable Service Parts

Storage

Troubleshooting Table

Common problems, their causes, and recommended solutions.

Weed Eater RT112C Specifications

General IconGeneral
BrandWeed Eater
ModelRT112C
CategoryTrimmer
LanguageEnglish

Related product manuals