8
JUMP STARTING YOUR ENGINE
1. Ensure your engine is completely OFF.
2. Securely connect the Smarty Clamps
®
to your Weego 22s.
3. Place your Weego 22s in a secure location.
4. Attach BLACK clamp to your battery’s negative (-) terminal, then the RED clamp
to your battery’s positive (+) terminal. Adjust your Smarty Clamps
®
to achieve
MAXIMUM contact with the terminals. Poor connections will prevent you from
starting your engine! Clear off any dirt or buildup with a wire brush or a dry towel
before connecting your clamps.
5. Check your Smarty Clamps
®
lights. When you have a GREEN READY light,
start your engine. If the engine doesn’t start, check your Smarty Clamps
®
lights and wait a minute before trying again.
6. After a successful start, disconnect the Smarty Clamps
®
from your Weego 22s.
7. Detach the Smarty Clamps
®
from the battery.
8. You’re now good to go - be sure to run your engine for at least 15 minutes before
shutting it off again so it has time to recharge your battery.
If you are having issues getting your engine started, see the Troubleshooting
section on page 10 or visit myweego.com/support for further details
and assistance.
WARNING!
Exposed Metal Jaws May Be HOT After Use!
To Next Page
Loading...
