6
Low Voltage Battery & BYPASS Feature
Low vehicle battery voltage: The Weego initially sees a weak but adequate
charge in the vehicle to jump start, but as soon as the engine turns over the
vehicle battery voltage drops to near zero volts.
BYPASS Feature: Weego allows for low vehicle battery voltage conditions
with an override feature called BYPASS. Pressing the BYPASS button will
allow power to the clamps so you can proceed with the jump-starting
attempt.
BYPASS on 44s & 70:
BYPASS on 120:
Stratified battery: A stratified battery will measure a healthy voltage
(~12.6V) at first, but as soon as you go to start the engine the voltage can
drop to below 1V, triggering the Weego to cut off power. A battery becomes
stratified when it’s been sitting around for months, and/or when it’s only
driven short distances (less than 15 minutes) for an extended time. You may
need a new battery.
MY UNIT WON’T POWER ON/CHARGE/CHARGE PAST A FEW LIGHTS.
If your unit won’t power on, won’t take a charge OR won’t charge past a few lights then it’s been
over discharged. This can happen if the unit is left ON, or if an engine pulled the Weego battery past
a certain limit during a jump start.
Please reach out to support@myweego.com to let them know about this issue – we’ll receive and
test the over discharged Weego, then determine if we can repair it or if it needs to be fully replaced.
To Next Page
Loading...
