6
Parameters Example:
• The following is a typ ical list of parameter changes that may be needed in ad dition to the factory default settings
(P204=5).
P000=5 Parameter Access (5 = Password)
P204=5 Loads Factory Default
P100=5 Acceleration Time = 5 seconds
P101=10 Deceleration Time = 10 seconds
P133=3.00 Minimum Fr eque ncy = 3.00 Hz
P134=60.00 Maximum Frequen cy – 60.0 0 Hz
• Local/Remote parameters allow the drive to be set up to operate from Keypad, Remote Terminal, or a
programmed combination of keypad and terminal inputs.
P221 – Local Speed Reference Selection
P222 – Remote Speed Reference Selection
P229 – Local Command Selection
P230 – Remote Command Selection
P231 – Forward/Reverse Selection
• Read Only Parameters (P002 – P040) can be used for monitoring and troubleshooting. For a full lis t and
description please read the CFW10 User’s Guide. By mo nitoring certain read only parameters, drive operational
values can be determined without the use of any other test equipm ent.
P002 – Frequency Proportional Value (Speed)
P003 – Motor Current
P004 – used to monitor DC Link Voltage.
P005 – Motor Frequency
P007 – Motor Output Voltage
P014 – Last fault
These are just a few examples of drive set-up and parameters. Please read the CFW10 User’s Guide for additional
information.
To Previous Page
Loading...
Need help?
General
