WARNING: FCC-Mandated Suppression of Radio Frequency Emissions
This is a
Class A product. In a domestic environment this product may cause radio
interference for which the user may need to take mitigating action.
If the Ethernet port has a cable connected to it, that cable must be properly shielded
and grounded to minimize RF emissions that could interfere with nearby equipment.
Circuit Protection and Earthing
When connecting the
iPump 562 to the power supply, review the ratings of all equipment in the circuit to ensure that the
branch circuit, as well as the power source, will not be overloaded. Also make sure that the unit is properly grounded and/or
that a protected power strip is used to attach it to the power supply.
Rear Panel Connections
iPump 562 rear panel view
iPump 562 Rear Panel Connections
Signal Connector Description
DC IN
Male Power Jack +12 VDC @ 5A
RF IN - Port 1
Type F 950 to 2150 MHz signal accepted. LNB power and Universal/Astra
signaling available
RF IN - Port 2, 3, 4
Type F (Optional) 950 to 2150 MHz signal accepted.
RS232 Port
RJ-12 Serial Asynchronous Data. May be used for terminal or printer
Audio OUT 2 (L/R)
2 RCA Phono Jacks Audio (stereo or mono L/R assignable)
GPIO
DB-9 Two Relays rated at 0.1A @ 30 V DC and one GPIO input for cued
file play.
Composite Video
RCA Phono Jack Composite Video NTSC or PAL
C-Video
RCA Phono Jack Composite Video NTSC or PAL
Component Video
3 RCA Phono Jacks Component SD/HD Video YPbPr
Audio OUT 1 (L/R
2 RCA Phono Jacks Audio (stereo or mono L/R assignable)
HDMI
Type A receptacle High Definition Multimedia Interface (Digital A/V)
S/PDIF
RCA Phono Jack S/PDIF Coax Digital Audio
S/PDIF
Optical TosLink S/PDIF Optical Digital Audio
Ethernet
RJ-45 Ethernet 10/100 BaseT
www.wegener.com 800092-02 Rev. C 3
To Next Page
Loading...
