Wegener iPump - Page 14

12 iPump Quick Start Guide
800009-02 Rev.B
8
88
8 For web browser control
For web browser controlFor web browser control
For web browser control
and status checking, first
navigate from the home screen to the IP Setup screen as follows:
Press
Display Field Type
a)
UNIT SETUP
Menu
b)
ENTER
RECORD AND PLAY
Menu
c)
DECODER SETUP
Menu
d)
AUDIO SETUP
Menu
e)
IP SETUP
Menu
Press
ENTER
and take note of the iPump's IP address displayed
on the screen. Then use the following steps to gain iPump
control from your web browser:
f) Using a computer on the LAN attached to your iPump,
open your web browser.
g) Type the IP address noted from the IP Address screen in
the browser's address box.
NOTE
: For IP addresses which include subfields with
leading zeros, you must omit those zeros when entering
the address in your browser. For example, IP address
128.092.056.004 would be entered as 128.92.56.4.
In some cases, it may be necessary to set specific values
for the IP and Subnet addresses. Consult your network
administrator.