M33 PowerKit Engine Operating and Maintenance Manual
DPK-MAN-EN-M33-0000-19-12-20
Société Internationale des Moteurs Baudouin Baudouin.com
Technoparc du Brégadan, 13260 Cassis, France (T) +33 488 688 500 (F) +33 488 688 501 10 of 55
SAS au capital de 33 311 180 € │R.C. Marseille 509 985 735 │Siret 509 985 735 00026
TVA intracommunautaire: FR 79 509 985 735 │ APE: 28111 – 08
Batteries
Wear personal protective equipment (PPE) as required.
Do not smoke in areas where batteries are charged or near fuel circuits.
The batteries release flammable fumes that can explode. Ensure there are no open
flames or sparks near the battery.
If the batteries are in a closed area, make sure there is sufficient ventilation.
The battery cables must be fitted with a circuit breaker to isolate the circuit.
Sulphuric acid contained in batteries is toxic and corrosive; it can burn clothes and
skin or even cause blindness in case of contact with the eyes.
Disconnect the batteries before any operation involving the electrical circuit
Never disconnect any charging unit circuit or battery cable while the charging unit or
battery is operating.
Never check battery charge by short-circuiting it.
Do not charge a frozen battery; heat it up to 16°C (61°F) beforehand.
In the event of contact with a body part:
Rinse the affected part with plenty of water.
Apply bicarbonate of soda or lime to neutralise the acid.
Rinse your eyes for 10 to 15 minutes.
See a doctor immediately.
In the event of ingestion see a doctor immediately.
Make sure the batteries are clean and fitted with the recommended covers, cables
and connections.
Electric wiring must be kept in good condition, properly positioned and soundly
attached.
Welding
Do not weld or flame cut pipes, hoses or tanks that contain flammable fluids.
Components containing flammable fluids must be drained and cleaned appropriately
with a non-flammable solvent before conducting any welding of flame cutting.
Comply with all legal provisions in force before conducting welding work.
Do not use open fires.
Make sure that the work will not affect the on-board electrical and electronic
equipment.
Make sure that the automatic fire suppression system is deactivated before any
welding or grinding work.
Make sure that there is sufficient ventilation in the premises where welding is to be
carried out.
To Next Page
Loading...
Need help?
General
