WP13 Diesel Engine Series Operating Manual
17
Figure 5-16 Exhaust the Air in the Strainer
Drain the water in the water collector
Attention!
When the water collector is full or the spinning filter has been replaced, it is necessary to drain the
water collected.
Steps (as shown in Figure 5-17)
A. Open the oil drain plug (2) at the bottom of the water collector (1) to drain the water;
B. Retighten the oil drain plug.
Figure 5-17 Drain the Water in the Water Collector
Replace the water collector.
Steps (as shown in figure 5-18)
A. Turn off the engine;
B. Drain the water in the water collector;
C. If possible, remove the collector screw (1) by hand. If it is too tight, use the handling tool in
the new water collector;
D. Use a few drops of oil to lubricate the sealing ring of the new collector (2);
E. Mount the screw by hand and use a tool to tighten it;
F. If the water collector is to be used again on a new spinning filter, check for any damage;
G. Use a torque wrench to install it at the torque of 20N.m.
To Next Page
Loading...
Need help?
General
