5
M10 Locknut (74)
M10 Washer (88)
12.7mm
Spacer (73)
M10 Curved
Washer (86)
14.8mm
Spacer (95)
6.35mm
Spacer (94)
M10 Jam Nut (99)M6 Locknut (87)
ST4.2 x 19mm
Screw (90)
M4 Locknut
(108)
PART IDENTIFICATION CHART
R
efer to the drawings below to identify small parts used in assembly. The number in parentheses by each draw-
ing is the key number of the part, from the PART LIST near the end of this manual. IMPORTANT: If you cannot
find a part in the hardware kit, check to see if it has been preassembled. To avoid damaging parts, do
not use power tools for assembly.
Continued on page 6
To Next Page
Loading...
