2608C.p65 25 ?2009/6/5, 下午 04:18
25
9427370000_00/06.2019
7. PE
AK ± Button
1. Record the peak+ or peak- value in a measurement. It is usable
with AC voltage, AC current measurements. If the pressed time >2
sec, the PEAK function will enter to calibration mode, the LCD will
show "CAL" and the intemal buffer will remember the intemal op o
ff
set v
oltage then back to the measure mode.
2. Response time: more than 1ms. 3.The recorded value of PEAK
f
unction will show on the sub-display, and the value being measur
ed
wi
ll show on the main-display.
8. MAX / MIN Button
The "MAX" displays the maximum value of measurements. The "MIN"
di
splays the minimum value of measurements. press MAX/MIN button
for more than 2 seconds to exit. The recorded value of MAX/MIN
function will show on the sub-display, and the value being measured
will show on the main-display.
9.
Backlight
Button
Press the button to activate the backlight for approximately 60
second.
10.HOLD
Button
Press [HOLD] button to toggle in and out of the Data Hold mode.
In the data hold mode, the " HOLD" annunciator is display
ed and
t
he last reading is held on the display.
Press [HOLD] button again to release the hold and current
readings are once again displayed.
11.
Trigger
Press the lever to open the transformer. When the lever is released,
the jaws will close again.
12.Transformer jaws
Pick up the AC or DC current flowing through the conductor. The "+"
m
arking on the jaw indicates direction of DC current existing on t
he
c
onductor being tested which follows forward and vertically with
jaws, and reading shown on display is positive.
To Next Page
