Weightworld CIRCULATOR - Recommendation; Device electrode patches body intensity

To Next Page

To Previous Page

23. Recommendation

Although it is not mandatory, we recommend you to apply balm on your feet to improve its

conductivity.

Important Note

Selected Program will be displayed every 5 mins for 10 seconds during the therapy in the

PROG/TIME display segment.

Please note that the optimal intensity level varies from person to person.

For optimum result, please do not lift your feet while the device is on.

The device should not be on the charging mode while in use

24. Device electrode patches body intensity

Sit down on a chair or a sofa and place your both bare feet on the foot

shaped pad of device and press the power button placed at the

bottom of device.

Step 1

Select the program PI or P2 by using the +/Prog/ Time button on the

device.

Step 2

Adjust the intensity through +/- foot intensity level buttons.

Continue to increase the foot intensity at your comfort level.

Step 3

As the device is set on Auto Timer for 30 mins, post 30 mins the

device will automatically switch off. Take off your bare feet and

restore the device in the bag properly.

Step 4

Auto shutdown after 30 sec in standby condition.

Shutdown procedure

Document No.: CWL-URM-04A | Revision No.: 00. | Revision Date: 20.06.2022

23 24

Circulator (Nerve & Muscle Stimulator) comes with one pair of reusable (up to 30 applications)

electrode patches that can be used to deliver electrical stimulation to the upper back, lower

back, shoulders, upper extremities and lower extremities.

Electrodes that have current delivered densities are 0.8 mA/cm².

Electrode patches are for single person use only. DO NOT share the electrode

patches with others.