Tech. Dok. / WNW 850 02 / 02.2005.A / © MICHAEL WEINIG AG Weinig Tools 1-9
Safety
1.3.1 Hydraulic tools
This operating manual must be read through completely by every authorized user before
working with Weinig tools. This must be confirmed in writing.
The Instruction Manual has been read and thoroughly understood.
Date: Signature:
Owner ................................ .......................................................
Operating personnel ................................ .......................................................
................................ .......................................................
................................ .......................................................
................................ .......................................................
Important:
This manual must be retained for future reference!
Hydraulic tools may only be clamped on the mounting arbor or spindle.
The clamping pressure (300 bar) on the hydro cutterhead and on the outboard bearing,
if applicable, must be checked daily with the aid of a high-pressure grease gun before
starting up the machine.
A safety collar must be used on the spindle.
The safety collars must not clamp the tool in axial direction. It must be clamped via the
hydraulic sleeves (300 bar).
The permissible clamping length must be taken into account when clamping hydraulic
tools on spindles without outboard bearing (see operating manual for the planer).
Further information on accident prevention is available on request from your employers'
liability insurance association. Please request this information.
To Next Page
Loading...