1-8 Weinig Tools Tech. Dok. / WNW 850 02 / 02.2005.A / © MICHAEL WEINIG AG
Safety
1.3 Tools and machine
The max. speed specified on the tool must never be exceeded.
All the tools described here are approved only for machines with mechanical feed.
Never use a damaged or dull tool.
Ensure correct direction of rotation of the tools.
Ensure that the machine cannot start up inadvertently while changing tools or cutters.
Tools must be fitted in the machine and secured as directed by the machine
manufacturer.
Before switching on the machine, ensure that the tools are correctly clamped.
Only switch on the machine when the statutory guards are in position.
Tools must never be fitted with cutters on one side only (asymmetrically), as this may
lead to imbalance. All cutters, clamping ledges and blind lugs, if required, must be fitted
without exception. Ensure that all cutters and blanks are of exactly the same weight.
The cutters must be distributed symmetrically when working with less than the full cutter
complement.
Ensure that the clamping areas are clean.
Ensure that parts are fitted correctly when changing cutters.
Ensure that cutters and tool are fitted flush (no protruding edges at the side of the tool).
Tools which have been heated as a result of cleaning in a washing machine or in any
other way must be allowed to cool before being installed. The tool clamp may loosen or
be reduced as the tool shrinks when cooling.
Only use original cutters and replacement parts.
To Next Page
Loading...