Turn the knob to select the welding material, then
press or press the knob to confirm and go to the
next step.
Selection of sheet thickness ("Thickness")
Turn and press the knob again to adjust the sheet
thickness and complete the settings. The system
will recommend the appropriate welding current.
Welding can start.
Welding current control ("Peak current")
If necessary, fine-tune the welding current.
8.4. Setting the TIG DC welding parameters
Selecting the type of current ("AC/DC")
Aluminum - AC mode (alternating current)
Stainless steel/mild steel/others - DC mode (direct
current)
To Next Page
Loading...
