8 of 10
Document Number: 9295087 03/12/2021
Subject: BIC Tune Up 2021 (USA)
66. Confirm “PLUNGE SPEED” is set at 15 and “CUP OFFSET”
is set at 2.0 from the easyToUCH screen:
Select the MANAGER MENU
Select “A” for the password
Select the GREEN check
Arrow DOWN once
Select SERVICE
Select “A” for the password
Select the GREEN check
Select Options
Arrow DOWN twice
Confirm the box to the left of PLUNGE SPEED is set
to fifteen (15), select box and enter 15 if required>
Select the GREEN check to confirm>
Confirm the box to the left of CUP OFFSET is set to
2.0, if required select the box and enter two (2), zero
(0), this will change the setting to 2.0
Select the GREEN check
Arrow back three (3) times
Select Save when prompted
67. Perform a calibration following the next steps from the
easyToUCH screen:
Select the MANAGER MENU Icon
Select “A” for the password
Select the GREEN check
Select CONFIGURE SLOTS
Select CALIBRATE FLAVOR
Select flavor in slot 1 and follow the onscreen
calibration instructions.
Continue calibrating each flavor, water, and ice.
68. Follow the next steps from the easyToUCH screen to
reset the LAST MAINTENANCE DATE:
Select the MANAGER MENU
Select “A” for the password
Select the GREEN check
Select the Down Arrow and select SERVICE
Select “A” for the password
Select the GREEN check
Arrow DOWN and select PLANNED MAINTENANCE
Select MIXER MAINTENANCE PERFORMED
Then type “SILENCE”
Select the GREEN check
You will get a message “Confirmation Blender(s)
Maintenance Done”
Save Changes
Arrow back to the Main easyToUCH Screen
REPLACE BLENDER SHAFTS
69. Turn power to unit OFF.
n
Warning
Blender shaft contains sharp blades. Wear cut resistant
gloves when handling. Do NOT touch the blades.
70. Remove grate from blender area then remove plastic
door.
71. Pull the cup holder approximately half way down in the
mixing chamber. Pulling the cup holder down will also
cause the blender shaft to lower.
72. Carefully lift the cup holder cover up as far as possible
to reveal the blender shaft.
73. With other hand rotate blender shaft to right until loose
from motor.
NOTE: Blender shaft is left-hand threaded.
74. Remove shaft by pulling down and tilting out.
75. Carefully lift the cup holder cover up as far as possible.
To Next Page
Loading...