9 of 10
Document Number: 9295087 03/12/2021
Subject: BIC Tune Up 2021 (USA)
76. Place the top of the new blender shaft into the top
opening in the cup holder and carefully thread new
blender shaft to the left into motor.
NOTE: Blender shaft is left-hand threaded.
NOTE: The shaft should only be hand tight; never use a
ratchet to install the blender shaft.
77. Replace grate in blender area.
78. Replace clear plastic door.
79. Repeat Step 70-Step 78 for other blender shaft.
80. Turn power to unit ON.
81. Reset blender cycle count.
Select BACK arrow.
Select MANAGER MENU.
Select A then press green check.
Select DOWN arrow.
Select SERVICE.
Select A then press green check.
Select DOWN arrow.
Select PLANNED MAINTENANCE.
Select MIXER MAINTENANCE PERFORMED.
Enter password for left or right side then press green
check.
• RIGHT side password: OEA422R
• LEFT side password: OEA422L
NOTE: Password begins with letter “O” NOT zero.
On confirmation screen select green check.
Select BACK arrow until reach easyToUCH screen.
82. Confirm blender counts and date reset.
Select MANAGER MENU.
Select A then select green check.
Select DOWN arrow three (3) times.
Verify blender cycle counts and date for shafts
changed have been updated.
83. Record DRINKS SINCE LAST MAINTENANCE DATE
on checklist after the new blender shafts have been
installed.
CONFIRM OPERATION
84. With the manager present make sample drinks of each
size.
85. Confirm operation of all functions.
86. Give removed parts to the manager.
87. Complete the Tune Up Checklist and confirm operation
with the manager.
88. Complete the Tune Up Checklist and fax to 920-683-
7592 or email to rise.callcenter@welbilt.com
89. Maintain a copy of the Tune Up Checklist to be
submitted along with the invoice for payment.
90. Submit claim for service work through Multiplex Claims
Processing System.
To Next Page
Loading...