Need help?Do you have a question about the Welch Allyn 53ST0 and is the answer not in the manual?
General| Model | 53ST0 |
|---|---|
| Manufacturer | Welch Allyn |
| Eartip Material | Silicone |
| Type | Stethoscope |
| Chestpiece | Double-sided |
Key safety points for monitor usage, placement, and environmental factors.
Describes the procedure for complete functional testing and preventive maintenance.
Steps for setting up the monitor and its power system for functional verification.
Procedure to characterize the NIBP module, including error code verification.
Procedure to test the NIBP system for abnormal leakage using a neonatal cuff.
Test to verify pressure readings against a calibrated external pressure meter.
Procedure to test the monitor's SpO2 function with Nellcor sensors.
Procedure to test the monitor's SpO2 function with Masimo sensors.
Procedure to test SpO2 function and verify sensor performance using a simulator.
Procedure to test the monitor's temperature function using a test key.
Procedure to test the temperature probe's accuracy with a calibration tester.
Overview of the patient isolation test, its importance, and required equipment.
A chart listing common symptoms, possible causes, and suggested actions for troubleshooting.
Explains the necessity and procedure for NIBP module characterization.
Detailed steps for initiating and completing NIBP characterization using the utility.
Describes the utility's interface for viewing and updating monitor software and firmware versions.
Step-by-step instructions for safely removing and disconnecting the monitor's battery.
Procedure for separating the monitor's front and rear chassis components.
Instructions for disassembling the front chassis, including the display board and keypad.
Instructions for disassembling the rear chassis, identifying its components.
Step-by-step guide for disconnecting cables and removing the main board.
Procedure for disconnecting tubing and removing the NIBP pump and module.
Procedures for removing the printer door, paper, and the entire printer assembly.
Procedure for removing the temperature module from the monitor's rear chassis.
Instructions for removing the Nellcor SpO2 assembly and its board from the rear chassis.
Procedure for removing the Masimo SpO2 assembly and its board from the rear chassis.
To Next Page
