Welch Allyn Connex VSM 6000 Series
Care & Routine Service
Maintenance and service
Replace the printer paper
The printer is located on the top of the monitor. Follow these steps to replace the roll of printer paper:
1. Grasp the two tabs and pull up to open the printer door.
2. Remove the empty core.
WARNING: Hot surface. Do not touch the printer mechanism.
3. Insert a new roll of paper.
Note: The paper roll must be installed as illustrated. If the paper roll is not installed correctly,
the printer will not print properly.
4. Thread the end of the roll past the roller so that it extends past the printer door, as shown.
5. With one hand, pull lightly on the paper to take up any slack. With the other hand, close the printer
door by pushing it down and into place until it clicks.
Be certain that the paper does not catch in the printer door.
To Next Page
Need help?
General
