2
CAUTION
Do not connect this appliance to power until all installation instructions are read,
understood, and followed. Damage to the unit, the counter, or users may result
if these instructions are not followed completely.
All servicing requiring access to non-insulated electrical components must be
performed by a factory authorized technician. Do not open any access panel
which requires the use of tools. Failure to follow this warning may result in severe
electrical shock.
Exposed surfaces can be hot to the touch and may cause burns. Contact with
the cooking surface can and will cause sever burns. Always wear protective
clothing and never make direct contact to the griddle surface.
Avoid storing flammable or combustible materials in, on, or near the unit.
Electrical installation other than as specified will void the UL certification listing
and may void the warranty. The ground lug of this appliance must be connected
to a suitable building ground.
Cleanliness of this unit is essential to good sanitation. Read and follow all
included cleaning instructions and schedules to ensure the safety of the
food product.
Do not submerge this unit in water. Do not direct water jet or steam jet at this
unit or at the controls or wiring. Do not splash or pour water on, in, or over any
controls, control panel, or wiring.
Do not stand or climb on the griddle. Any cracks in the unit due to standing
or climbing on the griddle will not be covered under warranty.
GENERAL SAFETY INFORMATION
This equipment is designed and sold for commercial use only, and is intended for use by personnel
trained and experienced in its operation. This is not sold for consumer use in and around the home
nor for use directly by the general public in food service locations.
Before using your new equipment, read and understand all the instructions and labels associated
with the unit prior to putting it into operation. Make sure all people associated with its use understand
the units operation and safety before they use the unit.
CERTIFICATIONS
These units conforms to NSF standard 4 for sanitation, but only if installed in accordance
with the supplied installation instructions and maintained according to the instructions
in this manual. 208 V, 240 V, and 480 V versions of these units are “U” listed under UL file
E6070. 380–415 V versions of the G13, G19, G23, and G24 griddles [as well as the same
models preceded by a “P” or “G”] are CSA and CE certified.
To Next Page
Loading...
