Wellue BP2A - 3.3 Recording ECG

10
measurement takes about 30s.
4. The readings will be displayed when the
measurement finished.
You can press Start/Stop button again to stop the
blood pressure measurement.
Note: During measurement, you should keep still and
do not squeeze the cuff.
3.2.5 After Measurement
The monitor will automatically release the cuff gas
after the measurement is over.
Press the button to turn off the power after the
measurement. Remove the cuff.
Note: The device has an automatic power shut-off
function, which turns off the power automatically in
one minute after measurement.
3.3 Recording ECG
3.3.1 Before Taking a Measurement
To help ensure an accurate measurement, follow these
directions:
 Before using ECG function, pay attention to the
following points in order to obtain precise
measurements.
 The ECG electrode must be positioned directly against
the skin.
 If your skin or hands are dry, moisten them using a damp
cloth before taking the measurement.
 If the ECG electrodes are dirty, remove the dirt using a
soft cloth or cotton bud dampened with disinfectant
alcohol.
 During the measurement, do not touch your body with