To start an ECG Recording:
1. Put your right palm on the right side electrodes of the
Monitor.
2. Put the left side electrodes to the body position that you
desired to measure.
3. Once the body parts are placed on the electrodes, press
Function button to start the EKG recording.
4. Wait for 30 seconds, the result readings will be displayed.
To start recording ECG again, press Start/Stop button to
return Home screen, then press Function button.
Note:
The recording must be at least 30 seconds to complete,
and to be analyzed by the detectors
You can get different signal amplitude from the different
methods. Usually, the signal from method A (Right hand
to left leg) is stronger.
3.3.3. Turn on/off Heartbeat Sound
The buzzer beep when heartbeat is detected during
ECG recording. You can turn on/off the heartbeat
sound on the App.
3.4 Review History Record
You can review the history results and replay the recorded
ECG waveform in History screen.
Hold Function button 2 seconds to enter History screen. The
last measurement result will be displayed in default
For ECG recording, the Heart Rate will be displayed first and
then replayed the 30-second ECG waveform.
To view next record, press NEXT button.
To exit History screen, press HOME button.
To Next Page
Loading...
