This device has been designed
to
operate
with
an antenna having a maximum gain
of
-2 dBi
at
2.4 GHz. Antenna having a higher gain is s
trictly
prohibited per regulations
of
ISED.
The required
antenna impedance is
50
ohms.
The maximum antenna gain
to
comply
with
the
EIRP
limit
is provided in
the
table below.
Antenna No. Antenna Type Antenna Gain (dBi)
Antenna Connector
BT IFA -2
N/A
Radiation Exposure Statement:
This equipment complies with
RSS
-
102
radiation exposure limits set
forth
for
an uncontrolled
environment.
Safety Caution:
When using this
product
, basic precautions should always be followed, including,
but
not
limited
to
,
the
following:
• Unplug device prior
to
cleaning. Use
dry
cloth on exterior
of
the
device. To avoid shock hazard
and/or damage
to
device, DO NOT use any liquid solution.
• Do
not
use this product near
the
water,
for
example, in a
wet
basement
or
near a swimming pool.
• Keep
this
product away from heat sources, direct sunlight, combustible
gas,
humidity, water,
or
other liquids.
• Do
not
use this product
if
visible defects are observed
or
if
it
has been wet
or
damaged
or
modified. Contact
the
customer service
support
of
Belkin
for
assistance.
• Do
not
disassemble, open, microwave, incinerate, paint,
or
insert foreign objects
into
this product.
• Do
not
expose this product
to
fire
or
high temperature. Exposure
to
fire
or
high temperature may
cause explosion.
• Do
not
expose this product
to
mechanical shock such
as
crushing, bending, puncturing,
or
shredding. Avoid dropping
or
placing heavy objects
on
this
product.
• Please read
the
operating instructions and information on
the
minimum and maximum operating
temperatures supplied with
this
product.
• To reduce the risk
of
injury, close supervision
is
necessary when this product is
used
near or by children.
• This product is intended for indoor use
only
.
• Use
of
this product in a manner
not
recommended
in
these instructions may result in a risk
of
injury
to
persons.
Fo
r support, please visit: http://www.wemo.com/support.html
Declaration
de
conformite
FCC
Nous, Belkin International, Inc., sis au 12045
E.
Waterfront Drive, Playa Vista, CA 90094, declarons
sous notre seule responsabilite que
le
produit
WSC010, auquel se refere
la
presente declaration,
est conforme aux normes enoncees a l'alinea
15
de
la
reglementation
FCC.
Le fonctionnement est
assujetti aux deux conditions suivantes : (1)
ce
dispositif ne
peut
pas provoquer d'interference
nuisible,
et
(2)
ce
dispositif
doit
accepter
toute
interference
rec;ue
, y compris des interferences
pouvant entrainer un fonctionnement non desire.
To Next Page
Loading...