we
mo
FCC
Compliance
Statement
We,
Belkin International,
Inc.,
of
12045
E.
Waterfront Drive, Playa Vista, CA 90094, declare under
our
sole responsibility
that
the
product,
WSC010,
to
which this declaration relates, complies
with
Part
15
of
the
FCC
Rules. Operation
is
subject
to
the
following
two
conditions:
(1)
this device
may
not
cause harmful interference, and (2) this device
must
accept any interference received,
including interference
that
may cause undesired operation.
This equipment has been tested and found
to
comply
with
the
limits
for
a
Class
B digital device,
pursuant
to
Part
15
of
the
FCC
Rules. These limits are designed
to
provide reasonable protection
against harmful interference in a residential installation.
This equipment generates,
uses,
and can radiate radio frequency energy and,
if
not installed and used
in accordance with the instructions, may cause harmful interference
to
radio communications.
However, there
is
no guarantee
that
interference will
not
occur in a particular installation.
If
this
equipment does cause harmful interference
to
radio
or
television reception, which
can
be determined
by
turning the equipment
off
and
on,
the
user
is
encouraged
to
try
to
correct
the
interference
by
one
of
the following measures:
• Reorient
or
relocate
the
receiving antenna.
• Increase
the
distance between
the
equipment and
the
receiver.
• Connect
the
equipment
to
an
outlet
on
a circuit different from
that
to
which
the
receiver
is
connected.
• Consult
the
dealer
or
an experienced radio/TV technician
for
help.
FCC
Caution:
Any
changes
or
modifications
not
expressly approved
by
the
party
responsible
for
compliance could void
the
user's
authority
to
operate this equipment.
This transmitter
must
not
be co-located
or
operating
in
conjunction
with
any other antenna
or
transmitter.
Radiation Exposure Statement
This equipment complies with
FCC
radiation exposure limits set forth
for
an
uncontrolled environment.
Innovation,
Science
and
Economic
Development (ISED)
Canad
a
Compliance
Statement
CAN ICES-003
(B)/NMB-003
(B)
This device complies
with
ISED's
license-exempt
RSS
standards. Operation is subject
to
the
following
two
conditions: (1) This device may
not
cause interference, and
(2)
this device
must
accept any interference, including interference
that
may cause undesired operation
of
the
device.
The device could automatically discontinue transmission in
case
of
absence
of
information
to
transmit,
or
operational failure. Note
that
this
is
not
intended
to
prohibit
transmission
of
control
or
signaling information
or
the
use
of
repetitive codes where required
by
the
technology.
This device and its antennas(s)
must
not
be co-located
or
operating
in
conjunction
with
any
other
antenna
or
transmitter except
in
accordance
with
ISED mul
ti-transmitter
product
procedures.
To Next Page
Loading...