11
ROUTINE INSPECTION
Before each use, inspect the general condition of the device. If any of the following conditions exist, do not use
until parts are replaced or the laser distance measure is properly repaired.
Check for:
• Loose hardware,
• Damaged batteries/electrical wiring,
• Cracked or broken parts, and
• Any other condition that may affect its safe operation
CLEANING & STORAGE
1. Wipe the device surfaces clean with a damp soft cloth. Make sure water does not get into the device. Do not
use any other solvents or cleaning agents to clean the device.
2. Maintain the reception lens with the same care as required for eye glasses or the lens of a camera.
STORING THE DEVICE
Always store your power device in a dry place, frost-free location. To protect the battery from damage, do not
store at temperatures lower than 14°F or higher than 104°F.
Remove the batteries before storing for an extended period of time.
DISPOSAL
When the product reaches the end of its lifetime, please do not dispose of it with household waste. Electrical and
electronic products are hazardous to the environment and human health due to the presence of hazardous sub-
stances. Take the product to your local recycling facility for it to be responsibly recycled to minimize impacts on
the environment.
Please recycle the packaging where facilities exist.
WARNING: To avoid accidents, turn OFF the laser before cleaning, adjusting, or performing any mainte-
nance or lubrication work.
WARNING:
Any attempt to repair or replace electrical parts on this device may be hazardous. Servicing
of the device must be performed by a qualified technician. When servicing, use only identical WEN replace-
ment parts. Use of other parts may be hazardous or induce product failure.
MAINTENANCE
To Next Page
Loading...
Need help?
General
