4
15. DO NOT OVERREACH. Keep proper footing and balance at all times. Wear oil-resistant rubber-soled foot-
wear. Keep the floor clear of oil, scrap, and other debris.
16. MAINTAIN TOOLS PROPERLY. ALWAYS keep tools clean and in good working order. Follow instruc-
tions for lubricating and changing accessories.
17. CHECK FOR DAMAGED PARTS. Check for alignment of moving parts, jamming, breakage, improper
mounting, or any other conditions that may affect the tool’s operation. Any part that is damaged should be properly
repaired or replaced before use.
18. MAKE THE WORKSHOP CHILDPROOF. Use padlocks and master switches and ALWAYS remove start-
er keys.
19. DO NOT operate the tool if you are under the influence of drugs, alcohol, or medication that may affect your
ability to properly use the tool.
20. USE SAFETY GOGGLES AT ALL TIMES that comply with ANSI Z87.1. Normal safety glasses only have
impact resistant lenses and are not designed for safety. Wear a face or dust mask when working in a dusty environ-
ment. Use ear protection such as plugs or muffs during extended periods of operation.
GENERAL SAFETY RULES
1. To reduce the risk of injury and electric shock hazards, unplug the air filtration system before replacing filters or
otherwise engaging in maintenance or service.
2. If mounting the air filtration system to the ceiling:
Make sure the bottom of the air filtration system is at least 7’ from floor level.
Anchor the air filtration system only to building structures capable of holding at least 100 lbs.
Do not anchor the filtration system to non-structural components such as drywall, false ceiling panels, etc.
3. Position the air filtration system so that it is at least 3’ away from any corner and from any heating, cooling, or air
circulation vents.
4. Do not use the air filter in environments that have poisonous gases, fumes, noxious smoke, or other chemical
risks. This filtration system is only designed to filter dust, airborne bacteria, small particles, etc.
5. Do not expose the air filtration system to water. Do not use in wet or damp environments. Failure to comply with
this instruction may cause damage to the unit and electric shock or other injury to the user.
6. Do not connect a power tool to expel waste or dust directly into the air filter. Doing so may damage the air filter.
7. This filtration system is designed to filter many airborne contaminants that may damage the human respiratory
system. However, the use of this system does not mean that other safety measures such as dust masks may be ig-
nored. Seek medical attention immediately if you experience any worrying respiratory symptoms.
SPECIFIC RULES FOR AIR FILTRATION SYSTEMS
To Next Page
Loading...
Need help?
General
