7
These safety instructions can’t possibly warn of every scenario that may arise with this tool,
always make sure to stay alert and use common sense during operation.
CHAINSAW SAFETY WARNINGS
CHAINSAW SAFETY
13. Only use this chainsaw to cut wood. Do not cut
plastic, masonry or other non-wood materials. Do not
use this chainsaw for anything other than its intended
purpose. Let the saw work at its own pace.
REDUCING KICKBACK
Kickback can occur when the tip of the guide bar touches
an object or when the wood closes in and pinches the
saw chain inside of the cut. Tip contact can kick the guide
bar up and back towards the operator. Pinching the saw
chain along the top of the guide bar can push the bar
rapidly towards the operator. Either of these reactions
may cause a loss in control of the chainsaw, increasing
the chances of serious personal injury. Do not rely on the
safety devices built into the saw. Chainsaw users should
take as many precautions as possible to minimize on-
site accidents. Kickback is the result of tool misuse and/
or incorrect operating procedures. These conditions can
be minimized with the following steps:
1. Maintain a firm grip, with thumbs and fingers encir-
cling the chainsaw handles. Both hands should be on
the saw with your body and arms in a position to resist
kickback forces. Kickback forces can be controlled by
the operator, if proper precautions are taken. Do not let
go of the chainsaw.
2. Do not overreach and do not cut above shoulder
height. This helps prevent unintended tip contact and
enables better control of the chainsaw in unexpected
situations.
3. Only use replacement bars and chains specified by
WEN. Incorrect replacement bars and chains may cause
chain breakage and/or kickback.
4. Follow the manufacturer’s sharpening and main-
tenance instructions for the chainsaw. Decreasing the
depth gauge height can lead to increased kickback.
WARNING! To reduce the risk of electric shock, always unplug the tool before performing any cleaning or
maintenance. Do not allow water to flow into the tool. Use a Ground Fault Circuit Interrupter (GFCI) to reduce
shock hazards.
To Next Page
Loading...
Need help?
General
