6
LOG SPLITTER SAFETY
7. MAKE all adjustments with the switch in the “OFF” position and the Log Splitter disconnected from the power
source.
8. Never use the log splitter for any purpose other than splitting wood. Any other use can result in injury. Use ex-
treme caution at all times.
9. PREPARE LOGS FOR SPLITTING. Make sure the log ends are cut square and cut off any branches flush with
the trunk.
10. INSPECT EACH LOG BEFORE SPLITTING. Make sure there are no nails or foreign objects in the log.
11. Only a single operator should load and operate the log splitter. Keep all others, including children and pets, a
minimum of 20 feet away from the work area.
12. NEVER TRY TO SPLIT LOGS larger than the rated capacity of the tool. Attempting to do so could result in
personal injury and damage to the tool.
13. Split only one log at a time. Do not attempt to split two logs on top of each other.
14. DO NOT put your hands or feet in between the log and the splitting wedge or between the log and the push
rod while the tool is in operation.
WARNING: KEEP HANDS AWAY FROM SPLITS AND CRACKS WHICH
OPEN IN THE LOG. THEY MAY CLOSE SUDDENLY AND CRUSH OR AMPUTATE
YOUR HANDS.
15. Do not attempt to load a log while the push rod is in motion. When loading, place your hands on the sides of
the log, not on the ends.
16. WAIT FOR THE PUSH ROD TO STOP MOVING before loading another log onto the log splitter. Do not
try to remove a split log until the entire splitting cycle is completed.
17. Use only your hands to operate the control lever. Never use your foot, knee, rope, or extension device.
18. Never use your hands to remove a jammed log. If a jam should occur, release the ON/OFF push button. Follow
the instructions in this manual for removing a jammed log.
19. Stack logs as you work. This will provide a safer, less cluttered work area.
ELECTRICAL INFORMATION
WARNING: To avoid electrical hazards, fire hazards, and damage to the tool, use proper circuit pro-
tection. The Log Splitter is wired at the factory for 120 V operation. Connect to a 120 V, 15-A circuit
and use a 15-A time delayed fuse or circuit breaker. To avoid shock or fire, immediately replace the
power cord if it is worn, cut, or damaged in any way.
To Next Page
Loading...
Need help?
General
