4
15. DO NOT OVERREACH. Keep proper footing and balance at all times. Wear oil-resistant rubber-soled foot-
wear. Keep the floor clear of oil, scrap, and other debris.
16. MAINTAIN TOOLS PROPERLY. ALWAYS keep tools clean and in good working order. Follow instruc-
tions for lubricating and changing accessories.
17. CHECK FOR DAMAGED PARTS. Check for alignment of moving parts, jamming, breakage, improper
mounting, or any other conditions that may affect the tool’s operation. Any part that is damaged should be properly
repaired or replaced before use.
18. MAKE THE WORKSHOP CHILDPROOF. Use padlocks and master switches and ALWAYS remove start-
er keys.
19. DO NOT operate the tool if you are under the influence of drugs, alcohol, or medication that may affect your
ability to properly use the tool.
20. USE SAFETY GOGGLES AT ALL TIMES that comply with ANSI Z87.1. Normal safety glasses only have
impact resistant lenses and are not designed for safety. Wear a face or dust mask when working in a dusty environ-
ment. Use ear protection such as plugs or muffs during extended periods of operation.
GENERAL SAFETY RULES
SPECIFIC RULES FOR THE JOINTER
1. Whenever adjusting or replacing any parts on the jointer, turn the switch OFF and unplug the power source.
2. Make sure all guards are properly attached and securely fastened.
3. Make sure all moving parts are free from interference.
4. Always wear eye protection or face shield.
5. Make sure blades are aligned and properly attached to the cutterhead.
6. Do not plug in the jointer unless the switch is in the off position. After turning the switch on, allow the jointer to
come to full speed before operating.
7. Keep hands clear of all moving parts and cutting surfaces. Handle the workpiece correctly. Protect your hands
from possibly injury.
8. Use quality lumber. Blades last longer and cuts are smoother with higher quality wood.
WARNING: For your own safety, read all of the instructions and precautions before operating the tool.
WARNING: Operation of any power tool can result in foreign objects being thrown into your eyes which can
result in severe eye damage. Always wear safety goggles complying with United States ANSI Z87.1 (shown on
package) before commencing power tool operation.
CAUTION: Always observe the following safety precautions:
To Next Page
Loading...
Need help?
General
