Wenger 70100 - Page 7

7
1. Pull out the crown to Position 2 (one «click» out). Rotate crown counter-
clockwise until the date shows one day earlier than the date you want to set.
2. Pull out the crown to Position 3 (two «clicks» out). Rotate crown so the
watch hands move clockwise until the current date shows. Then set the watch
hands to the correct time. Turn the watch hands past 12 once if you’re setting
the watch for a P.M. time. Push the crown back to Position 1.
3. For a watch with day and date display, pull out the crown of the watch to Po-
sition 2, turn it clockwise to change the day and counterclockwise to change
the date.
4. Return the crown to the fully depressed Position 1, assuring the crown has
been further screwed down on all diver watches.
For Watches Without a Date Display
1. To set the time for watch without date display, pull out the crown to Position
2. Turn the crown either clockwise or counterclockwise to set the correct
time.
2. Return the crown to the fully depressed Position 1, assuring the crown has
been screwed down on all diver watches.