To Next PageTo Next Page
Need help?Do you have a question about the Werner Telescopic Extension Ladder Series and is the answer not in the manual?
Read and follow instructions, ensure fitness to use, handle with care, and deploy correctly.
Maintain correct angle, use wall bumpers, check locks, wear suitable footwear, and maintain grip.
Avoid electrical hazards, slippery surfaces, water, misuse, overreaching, and climbing restrictions.
Ensure all locking mechanisms are functioning correctly before use.
Extend the ladder starting from the lowest section upwards until the desired length is reached.
Deploy the ladder at a 75-degree angle with feet and bumpers correctly positioned against a surface.
Support the ladder upright and depress lock release buttons to unlock sections.
Hold stile tubes and slowly pull down sections for sequential closing.
Handle the ladder with care and store it in suitable conditions indoors.
Keep the ladder clean by wiping stile tubes and cleaning after exposure to wet conditions.
Replace worn ladder feet and safety grip wall bumpers with genuine parts.
Read instructions, ensure fitness, check suitability, inspect for damage, and remove contamination.
Consider collision risks, secure doors, check electrical risks, use firm surfaces, and correct angle.
Maintain grip, keep belt buckle within stiles, avoid side loading, and do not overreach.
Carry out repairs by competent persons and store ladders according to producer's instructions.
Inspect stiles, fixings, rungs, feet, and overall condition for damage or wear.
Replace worn parts like bumpers and feet; seek professional advice for repairs.
Store away from deterioration, vertically, protected from damage, and secure.
General
