AM 334-01-502
36
8. Plug-in Board SL 3 - Slave Processor
Fig. 16 shows the component layout of plug-in board SL 3;
Fig. 15 is the schematic diagram.
The following test enlarges upon the initial test of the slave
processor in the assembly manual, enabling you to
completely check every voice on every slave. Proceed as
follows:
a) Turn on the organ; if already on -
b) Press "Reset."
c) Press "Compute."
d) Select the slave:
Press one of the five switches W, E, R, S, I, depending
upon the slave you wish to test:
W for Slave 1 (immediately beside the master proces-
sor board)
E for Slave 2
R for Slave 3
S for Slave 4
I for Slave 5
If, for example, you wish to test Slave 3, press R.
e) Select the voice:
Again, press one of the five switches:
W for 1st voice
E for 2nd voice
R for 3rd voice
S for 4th voice
I for 5th voice
Again, by way of example, if you have selected Slave 3
and wish to test the 1st voice, press W.
f) Select any DMS instrument (the Horn, for example) and
play on the selected manual. The organ will now sound
only monophonically, that is, only one tone is produced
at a time and both of its components' become slightly
apparent and can be evaluated by moving the slide
controls Chan. I and Chan. 2 up or down. Listen for
possible problems such as noise, distortion or a missing
component.
g) Test other slaves by pressing "Reset," "Compute" and
proceeding as above.
To Next Page
Loading...
Need help?
General
