EasyManua.ls Logo

Wesco C86 - OPERATION AND USE; Pre-Wash Operational Checks; Detergent Dosing and Dishware Loading; Initiating Automatic Wash

Wesco C86
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSTRUCTIONS FOR THE USER
17
OPERATION AND USE
1)Before washing make sure that:
the wall-mounted on/off switch is switched on;
the water tap is open;
water is present in the distribution network;
the pump protection filters are installed in their respective positions;
the overflow in inserted;
all rotating parts are free;
the rinse aid dispenser is full;
make sure that dishware is in good conditions as it may cause cleaning
difficulty and haven bacteria.
2)Set switch "Q1" to position to enable the automatic wash tank
filling and the consequent triggering of the heating element.
The lamp "H1" is on.
3)As soon as visual indicator "H2" is ON, pour about 45 gr. of detergent
directly into the tank, paying attention to distribute it uniformly on the filters,
the quantity being according to supplier's instructions. Add 15 gr. every 7
cycles to achieve a concentration of 1,5 gr./lt. In order to respect our
environment, use only the correct amount of detergent.
When using chlorinated detergent, it is suggested to use an automatic
dispenser; otherwise, brownish spots might appear on the surfaces due to
chlorine reactions. Detergent should always be placed near the pump filter.
4)Then, introduce the glasses or the cups to wash, after having removed the
solid waste and having placed them into the proper racks. The cups and the
glasses should be turned upside down, while the cutlery should be put
vertically into the proper container, and the same applies to dishware.
5)By means of switch "Q1" select the wash cycle according to conditions of
the dishware:
-pos.
- short cycle: with glasses or cups.
-pos.
Q1
- medium cycle: with normally dirty dishes or cutlery.
-pos.
Q1
- long cycle: with particularly dirty dishes or deep
dishes.
A manual wash is possible by operating main switch "Q1" in the positions
Q1
and by pressing the "S3" button activates the wash cycle for a
maximum time of 8 min and 20sec. To interrupt the wash cycle press "S3".
The pause and rinse cycles will follow and if incorporated also the drain
cycle.

Related product manuals