INSTRUCTIONS FOR TECHNICAL PERSONNEL
26
WIRING DIAGRAM
C1 Anti noise filter
C3 Condensator
E2 Booster heater
E3 Tank heater
F3 Wash pump overload relay
H1 Pilot lamp power on
H2 Pilot lamp machine ready
H3 Pilot lamp machine working
KE2 Booster heater contactor
KE2b Safety contactor of booster heater
KE3 Tank heater contactor
KM2 Rinse pump relay (if required)
KM3 Wash pump contactor
KM5 Drain pump contactor (if required)
M2 Rinse booster pump (if required)
M3 Wash pump
M5 Drain pump (if required)
MD Detergent dispenser (if required)
Q1 Main switch
S1 Door switch
S2 Pressure switch
S3 Cycle start push button
S4 Regeneration switch (if required)
S5 Drain pump push button
S7 Automatic/manual start selector
SE2 Booster thermostat
SE2a Booster thermostat
SE2b Booster safety thermostat
SE3 Tank thermostat
T1 Transformer
X1 Junction
Y1 Solenoid valve
Y4 Regeneration solenoid valve (if required)
The manufacturer declines any responsibility for any printing errors
contained in this booklet. The manufacturer also reserves the right to make
any modifications to its products that do not affect the basic characteristics
thereof.
To Next Page
Loading...