9
5. While a second person holds the Rail (4) near
the Frame (2), connect the Rail Wire (10) to the
Frame Wire (11). Insert the excess wire into the
Rail.
Tip: Avoid pinching the wires. Attach the Rail
(4) to the Frame (2) with an M8 Bolt Set (12).
Then, insert the Frame Pin (13) through the
indicated holes.
2
12
12
13
11
10
5
6. Insert the Axle (14) through the Frame (2) and
center it. Next, slide a Bushing (15) and a Pedal
(16) onto each side of the Axle.
Then, tighten an M8 Nut (17) and an M8 Washer
(24) into each end of the Axle (14) at the same
time.
4
Avoid
pinching
the wires
2
14
16
15
15
16
17
24
17
24
6
7
7. Clip the Row Bar (18) or the Handles (19) to the
Bungee Cords (20).
20
18
19
To Next Page
Loading...
Need help?
General
