4 FJWESTCOTT.COM
Clean sides of flash unit with rubbing
alcohol. Cut the included self-adhering
hook-and-loop tape in half and place
on each side of your flash unit. For
maximum adhesion, allow it to cure for
24 hours before attaching the Apollo.
Remove flash unit from the camera.
Do not attach the Micro Apollo while
flash is mounted to the camera.
Place the Micro Apollo face down on
a flat surface. Lift up one side arm and
attach swivel-pad with hook and loop
tape to the hook and loop tape on the
side of the flash unit. Repeat this step with
the other side arm.
Adjust the Micro Apollo so it is evenly
mounted on the flash unit and faces
straight ahead. Press the swivel-pads firmly
against the sides of the flash unit to insure a
firm attachment. Make sure the cloth cover
is stretched tight and the elastic opening
is closed around the flash unit. Mount flash
unit on camera and you’re ready to go.
Micro Apollo
™
Setup UsagE
#2200 CONTAINS: [1] Micro Apollo [1] Piece hook-and-loop tape
1 2
3 4
To Next Page
Loading...
