To Next PageTo Next PageWhy did the fumes NTC trip due to overtemperature in my Westen Boyler Condens 24?
If your Westen Boiler indicates 'Fumes NTC tripped due to overtemperature', check the heat exchange of the water/fumes exchanger for insufficient circulation or the presence of scale. Also, check the fumes NTC probe.
What causes gas valve blocked error in Westen Boiler?
If your Westen Boiler displays 'Gas Valve Blocked', check the gas supply pressure. Verify the integrity and position of the sensing and ignition electrodes and their wiring. If necessary, replace the electronic board.
What to do if fumes outlet is obstructed in Westen Boiler?
If your Westen Boiler shows 'Fumes Outlet Obstructed', check that the drainage pipe is free from obstructions. Additionally, switch off the electric power supply to the boiler for a few seconds.
How to troubleshoot a fan fault in my Westen Boyler Condens 24 Boiler?
If your Westen Boiler displays 'Fan Fault', verify the correct operation of the fan. Also, check that the fan power supply wiring is connected to the electronic board.
What causes loss of flame at ignition in Westen Boiler?
If your Westen Boiler experiences a 'Loss of Flame at Ignition', check that the flame sensing electrode is in good condition and correctly positioned. Also, ensure the wire is uninterrupted and makes good contact with the flame sensing electrode and the ignition switch. Check for any recirculation of fumes.
How to fix safety thermostat tripped due to overtemperature in Westen Boyler Condens 24?
If the safety thermostat in your Westen Boiler trips due to overtemperature, which may be caused by a blocked pump or air in the heating circuit, check the pump operation by unscrewing the front cap and releasing the pump impeller with a screwdriver. Also, check the pump power input wiring and ensure the limit thermostat is undamaged, replacing it if necessary. Finally, check the continuity of the limit thermostat wiring.
What to do if my Westen Boyler Condens 24 Boiler has ignition failure after 5 attempts?
If your Westen Boiler displays an 'Ignition Failure (5 attempts)' error, ensure the gas valve is open and there's no air in the gas supply circuit. Check the gas supply pressure and verify the wire is uninterrupted, making good contact with the flame sensing electrode and the ignition switch. Also, check the correct operation of the condensate drainage. Further actions may be indicated in E92.
General| Type | Condensing |
|---|---|
| Max. Thermal Power (Heating) | 24 kW |
| Mounting | Wall-mounted |
| Warranty | 2 years |
| Fuel Type | Natural Gas |
