Westerbeke 55B-FOUR - Preparations for Initial Start-Up

PREPARATIONS FOR INITIAL START-UP
PRESTART INSPECTION
Before starting your engine for the first time or after a
prolonged
layoff, check the following items:
D Check the engine oil level. Add oil to maintain the level
at the high mark on the dipstick.
D Thrn on the fuel supply, then check the fuel supply and
examine the fuel filter/water separator bowl for
contaminants.
D Check the transmission fluid level.
D Check the DC electrical system. Inspect wire connections
and battery cable connections. Make certain the positive
(+) battery cable is connected to the starter solenoid and
the negative (-) cable is connected to the engine ground
stud (this location is tagged).
D Check the coolant level in both the plastic recovery tank "A<"~P~ 19~ti
and at the manifold. ":.;:.;j'!j ~1N'"~ ~
NOTE: If the engine luls not yet been filled with coolant,
refer to the COOUNG SYSTEM section of this manual.
D Visually examine the engine. Look for loose or missing
parts, disconnected wires, and unattached hoses. Check
the
threaded connections and engine attachments.
D Make certain there is proper ventilation around the
engine. An ample supply is necessary for proper engine
performance.
D Make sure the mounting installation is secure.
D Ensure the propeller shaft is securely attached to the
transmission.
D Open the thru-hull and make certain raw water is primed
to the raw water strainer.
TOP Oil Fill
TO THERMOSTAT
HOUSING
DIPSTICK
....v' WESTERBEKE
Engines' & Generators
8
COOLANT EXPANSION