WESTERLY Konsort 29 - Page 50

Freshwater Cooled
Engines
uit.
system.
The heated
seawater
is
then
injected
into
tho
ei<haust
system
for
discharge.
This typö
of engine
runs at a
slightly
higher temperature.
Water
Filter
This
basic
strainer
is
a bulkhead
mounted black cylinder
approximately
5"
in diameter.
For inspection,
the
cap
uhbcrews
anfi-clockwise
allowing access
to the coarse
wire
mesh
filter.
Notes:
1 Ensure cap
ls not
cross-threaded
when
replaced.
2
Ensure
cap
ls
screwed
down
tightly
to
prevent
air
ingress. This can cause
damage to
the impellor and
the engine
il
overheating
occurs.
EXHAUST
SYSTEMS
can
further
be avoided
in two ways:
1 Close the inlet
stopcock
several
seconds before
stopping
the
engine.
2 After three
or
four
attempts
to
start
a stubborn
engine,
close
the
inlet
stopcock untilthe engine
starts.
4.4