Westermann WR 870 Honda PRO User Manual (English)

Other manuals for Westermann WR 870 Honda PRO

Questions and Answers:

J
Joseph MccarthyAug 5, 2025
What to do if the brush on my Westermann WR 870 Honda PRO doesn't turn even after moving the direction change lever?
- J
  Jacqueline HebertAug 5, 2025
  If the brush on your Westermann Floor Machine does not turn despite moving the director change lever, consider the following: * Ensure the direction of rotation change lever is in the correct drive position. * Check the V-belt and replace it if defective. * Tighten the drive belt tensioning bolt. * Adjust the toothed belt tensioning device if the timing belt pretension is insufficient (lever can be pushed beyond the intended holes).
B
Brandon DillonAug 9, 2025
What to do if the brush on my Westermann WR 870 Honda PRO Floor Machine does not turn or stops at low resistance?
- J
  James BrooksAug 9, 2025
  If the brush on your Westermann Floor Machine doesn't turn or stops when it meets low resistance, it could be due to: 1. A defective V-belt: Inspect the V-belt and replace it if necessary. 2. A defective toothed belt: Examine the toothed belt and replace if needed. 3. Insufficient drive belt pretension: Tighten the drive belt.
C
charles20Aug 14, 2025
How to fix a Westermann WR 870 Honda PRO brush that does not turn correctly?
- T
  Teresa MillerAug 14, 2025
  If the brush on your Westermann Floor Machine isn't turning correctly, check these potential causes: * Ensure the direction selector lever is in the neutral position. If not, move it to neutral. * Adjust the sweeping height to suit the conditions. * Check all screws and tighten any that are loose.