19. Command Codes EXPLANED
above which the vending machine goes out of service - will show
a warning message. This control is inhibited when turned on
and after closing the door for the time set in Command 45. The
preset value is +8°c but can vary from +8°C to +25°C.
To reset the fridge safety device - with the door open, the
vending mchine display shows that the device has tripped. Reset
by pressing ENTER on the keypad. If you press ESC or close the
door - the intervation remains and record as ERROR 93.
Command 50: Setting the delivery door speed and drum
operation parameters
This command allows you to change the operating speed of the
delivery doors. The value is expressed as a percentage of the
maximum speed and can vary from 40 - 95%. It is preset at 60%.
It is also possible to carry out drum positioning tests.
Command 51: Setting the refilling mode
Refilling modes:
0 - FAST Refilling - completely refilling the machine - carried out
by opening and closing the door.
1 - NORMAL Refilling - by drum. Enter drum number and fill -
must be done with door open.
2 - SMART Refilling - used when products are sold by sell-by
dates. This is carried out with the door closed, and filling occurs
through the delivery doors.
C O M M A N D S T O S E T M A C H I N E P A R A M E T E R S
To Next Page
Loading...
