Command 69: Chooses functioning mode of coin
mechanismThis command chooses the type and mode of
functioning of the coin mechanism.
0 = System EXECUTIVE with prices controlled in the machine
1 = System EXECUTIVE in PRICE HOLDING mode (i.e. prices
programmed in the coin mechanism). In this case, the prices
programmed at Command 03 and those programmed in the
coin mechanism must be the same. Alternatively you can set the
"Price-Display" parameter - the machine will utilise exclusively
the information on the price value from the payment system,
simply set only Command 05.
4 = System BDV 001
5 = Payment System MDB - Default Setting
Command 71 - 80: Drum parameters
These commands are for setting up the number of
compartments set for the selected drum. For example enter
Command 71 (this corresponds to drum 1), "Compartment No.
XX" is displayed and shows the number of compartments set for
this drum. The values are: 4, 6, 8, 12, 16, 24, 48. Press ENTER to
confirm. The the machine will give the functioning mode
"Fifo/shopper X". If value 0 - drum is set in shopper mode / If
value 1 - drum is set in Fifo mode - products only available for
sale in order they were loaded. Confirm ENTER. Then "Expiry
days YY" - YY indicates the shelf life of the products loaded in
the selection starting from the preceding midnight - only
operative in "Intelligent Reload" mode.
19. Command Codes EXPLANED
C O M M A N D S M B D C O I N S Y S T E M S A N D D R U M S E T U P
To Next Page
