To Next PageTo Next PageWhy is the cut uneven or untidy in one or more sectors on my Westwood T Series Lawn Mower?
If your Westwood Lawn Mower's cut is uneven or untidy in certain areas, ensure the cutter deck is correctly leveled from front to back. Also, verify that the blades are not worn or damaged.
What to do if the PGC or other accessory fails to operate on Westwood T Series Lawn Mower?
If your Westwood Lawn Mower's PGC or other accessory fails to operate, verify that fuse 4 hasn't blown and that the PGC safety plug is connected to the tractor. Also, check if the battery has lost charge, as this can prevent the clutch from operating.
What to do if the tractor display fails to light up when turned on, or the tractor doesn’t start on Westwood Lawn Mower?
If your Westwood Lawn Mower's tractor display fails to light up when turned on, or the tractor doesn’t start, check that fuse 6 has not blown.
What to check if the engine fails to turn over on Westwood Lawn Mower?
If the engine fails to turn over on your Westwood Lawn Mower, make sure the handbrake is on and you are sitting on the seat. Check that the battery terminals are connected, fuse 6 (yellow 20 amp ignition fuse) has not blown or been dislodged, and the battery is charged.
General| Brand | Westwood |
|---|---|
| Model | T Series |
| Category | Lawn Mower |
| Language | English |
Explains signal words, alert symbols, and decal meanings for safe operation.
Covers training, age, children, and personal protection for safe use.
Details on operating conditions, slopes, fuel, towing, and accessories.
Safety for batteries, service, transporting, and storage.
Details on choke, ignition switch, RMO system, and throttle controls.
Instructions on moving, stopping, parking, and transmission bypass.
How to engage and operate the cutting deck and RMO system.
Using the PGC, engaging PTO, and net emptying procedures.
Instructions for installing the deck tension rod assembly for belt tension.
Steps to adjust the tension rod for proper belt tension.
Diagnosing engine start, restart, misfires, power loss, and stalling.
