Need help?Do you have a question about the Wet Sounds HT-1 and is the answer not in the manual?
General| Channels | 1 |
|---|---|
| Signal to Noise Ratio | >90 dB |
| Bass Boost | 0 - 12 dB |
| RMS Power @ 2 Ohms | 600W x 1 |
| RMS Power @ 1 Ohm | 1000W |
| Input Sensitivity | 0.2V - 6V |
| Power Output | 1000 Watts |
Crucial warnings about high volume listening and installation precautions.
Instructions for proper amplifier mounting and location selection.
Guidance on running wires and connecting power and ground.
Explanation of the amplifier's LED for operational status.
Connecting the remote signal and audio inputs for operation.
Description of the optional remote knob for output adjustment.
Instructions for using the removable terminal blocks for speaker connections.
Overview of Gain, Phase, Crossover, and Bass Boost controls.
Details on RCA input specifications and remote level control.
Locating speaker, power, ground, and remote terminals.
Information on the amplifier's protective fuses.
Procedure for optimizing input sensitivity for desired output.
Understanding and adjusting the crossover frequency.
Adjusting Bass Boost and Phase for sound optimization.
Steps to resolve common amplifier issues and protection modes.
Diagrams for connecting single and dual subwoofers.
Measurements of the amplifier and comparison chart.
Detailed specifications including power, impedance, and signal-to-noise ratio.
Details on warranty coverage, exclusions, and obtaining service.
To Next Page
